STEP-BY-STEP INSTRUCTIONS FOR ROD INSTALLATION

STEP 1:
1. MAKE SURE THE GUN IS SAFE.
2. REMOVE THE SLIDE FROM THE FRAME.
3. REMOVE THE STOCK GLOCK® RECOIL ROD.

STEP 2:
INSTALL THE BUFFER TECHNOLOGIES GK1 BUFFER IN THE NOSE OF THE SLIDE - (YOU CANNOT MAKE A MISTAKE - THE ONLY WAY IT WILL FIT IS WITH THE EARS AGAINST THE SLIDE RAILS AND THE ROUND PART FACING UP). **Buffer Tech buffer shown only for reference purposes only

STEP 3:
1. PLACE YOUR DEAD BANG RECOIL ROD INTO THE SMALL END OF THE WOLLF SPRING.
2. PLACE THE ASSEMBLED ROD/SPRING INTO THE GK1 BUFFER AND INSTALL BACK ONTO THE BARREL.

**Buffer Tech buffer shown only for reference purposes only

HELPFUL HINT FOR FULL-SIZE GLOCKS: UNTIL YOUR SPRING BREAKS IN (AFTER ABOUT 50-100 CYCLINGS), KEEP THE SPRING PARALLEL TO THE BARREL AS CLOSE AS POSSIBLE AND WALK THE ROD THROUGH THE SPRING UNTIL IT GOES THROUGH THE HOLE IN THE SLIDE. IT WILL BE A LITTLE STIFF AND UNTIL THE SPRING BREAKS IN AND YOU BECOME PROFICIENT YOU WILL NEED A LITTLE PATIENCE.

YOU ARE DONE! PLACE THE SLIDE BACK ON THE FRAME AND ENJOY THE REDUCED RECOIL REDUCTION OF YOUR "NEW GUN".

back to top